Tired of tangled cables ruining your workspace? From sticky residues left by adhesive clips to permanent damage caused by drilling, traditional cable management solutions often do more harm than good.
Enter the 3D-printed 5-port cable organizer from Bambu Lab MakerWorld creator, CatMaster Lab—a genius, hardware-free solution that clamps to your desk edge to keep your setup pristine without sacrificing any surface space.
This vibrant yellow accessory is simplicity at its best, consisting of just a base and a thumb-tightening knob. The design is a masterclass in 3D-printing optimization: the threads are rock-solid, and the ergonomic plum-shaped knob ensures a secure fit without needing a single tool.
But it’s the five elastic slots that truly shine. They keep your cables separated, tangle-free, and protected by rounded edges that prevent wear and tear.
Installation is a breeze: clamp it on, tighten it, and you're done. No glue, no holes, no mess. Because it hangs off the edge of your desk, your workspace remains completely open. Whether you’re running thick braided cables or thinner power cords, this organizer handles them with ease. It’s smooth, efficient, and ensures that when you need a cable, it’s exactly where you left it.
At just 27.1g, this project is the ultimate low-cost, high-impact DIY win. It’s non-destructive, portable, and compatible with almost any desk surface. If you’re a fan of 3D printing and a cleaner desk, this is one project you need to print today.
Related Articles：
1. 7050mAh Battery | Charging Compatibility Test of OPPO Find X9 Ultra
2. STIHL Goes Tabless, The New ALLPRO Battery System Redefines Power Tool Performance
3. Battery enterprise efficiency, a dual-dimensional look at revenue and profit per capita
